Mystery solved, sort of. Early in 2024 a number of strange drones...

@DanielR_PhD
DanielR PhD@DanielR_PhD
39 views Dec 16, 2024 ~4 min read
Advertisement
1
1. Mystery solved, sort of. Early in 2024 a number of strange drones crashed in russia: a typical wreckage is shown here. I spent a lot of time trying to determine who made these but recently the manufacturer publicity announced this drone 🙃. Regardless, here is what I found.
Media image
2
2. It’s not a secret but it is an interesting design. The fuselage is a carbon-fibre cylinder with fancy aluminum bulkheads. Wings and V-tail are composite construction with foam and wood internal structures. This is an expensive airframe compared to some other drones.
Media image
3
3. This photo gives an idea of its size. The power & programming ports are visible here. Intact propellers indicate these 2 drones crashed because the engines were not running. There are very nice mounts for the wings & tail fins.
Media image
4
4. Several of these drones have been captured. This one (in a kitchen) is hardly scratched and the warhead is still in place 🤔. Just aft of the GPS antenna there is a curious feature that might be a safety switch. There is an antenna connector on either side of the fuselage.
Media image
5
5. A top view of fuselage gives a better view of the GPS antenna and a curious feature whose purpose is a mystery. Also visible is the panel holding the LEDs and power & programming connectors.
Media image
6
6. The wings and tail fins are typical composite construction. One interesting detail is a very long pitot tube is mounted on the tip of a tail fin instead of in a wing. The servos have stylish green covers.
Media image
7
7. The engine is a US-made Desert Aircraft DA-150. The black (not red) sensor means this is the commercial, not hobby, version. The roughly-machined case is slightly heavier but cheaper than a fully machined case. Thus, this engine was intended for use on target drones.
Media image
8
8. There have been a number of variations of this drone’s flight control board. It’s based on a CubePilot Cube Orange+, which is an open-source autopilot used in many commercial & up-scale hobby drones. It is also used in the Syspaq Corvos cardboard drone.
Media image
9
9. A curious feature is that flight controller can use either a RFD900 radio modem or a WIZ750SR ethernet module. The RFD900 connects to 2 antennas mounted on either side of the fuselage. The WIZ750SR is likely for when a satellite modem is used.
Media image
10
10. The radio modem & ethernet module are standard off-the-shelf parts. However, I do not recall seeing one of these drones using the ethernet module. They all used the RFD900 or possibly an unknown radio.
Media image
11
11. It uses a Novatel 719 GPS receiver with an Antcom active antenna. Although off-the-shelf, this is well above hobby grade (i.e., it’s probably expensive). One curious feature is the carrier board requires a hole for the antenna cable to pass through.
Media image
12
12. This drone was a mystery until @AEVEX_Aerospace publicly announced this it as the Disruptor. They now provide a lot of information on this drone, thus reducing the value of this thread by quite a bit. It is nice to see what it looks like when not crashed 🙂.
Media image
13
13. At this point the story would normally end - except for one detail. The crashed drones’ propellers had the word “Front” handwritten on them. This exact same writing appeared on propellers of a different drone. This meant they were almost certainly made by the same company.
Media image
14
14. This drone has very similar electronics to the Disruptor, so there is no point in going into a detailed analysis. The motor mount is very nicely made. These drones have been observed very far behind front lines.
Media image
15
15. One point worth noting is the flight controller board is very similar to that shown in #8. This means they probably use the same firmware and ground station, which should not be a surprise.
Media image
16
16. This drone is the Dagger also by Aevex. These drones have been in Ukraine since at least January, 2023 and significant advances in their designs have been observed. The flight control board has seen several iterations so the information shown here is likely out-of-date.
Media image
17
17. None of this information will aid russians who have captured many of these. In fact, the russians provide helpful reviews such as, “The motherboard has noticeably become prettier, the placement of blocks has acquired logic.” Also noted by russians is, “the top reason [for crashes] is that the propeller nut was not tightened”
Media image
18
18. Lots of these drones have been observed by unhappy russians. The steady advances in their designs illustrates how important experience in Ukraine is for drone development. If you enjoyed this thread, please repost as a quote. Respectful comments are welcome & always read.
Media image
19
19. (ps) If this thread seems odd, it’s because I spent months trying to sort out these drones only to have that effort evaporate when Aevex made this information public. Regardless, it has been super interesting seeing how these have evolved during this war. Also, if you are trying to remain secret, do not sign the propellers.
Media image
20
20 (ps) The Aevex Dominator has similar electronics and has been used in Ukraine for a least a year.
It is interesting that these US-made weapons were striking far into russia almost two years before the US government publicly okayed it.
Media image
Actions
What You Can Do
  • Export as PDF or Markdown
  • Batch Export to Notion
  • Bookmark & Highlight
  • Screenshot Tweet
Create Free Account

Includes 7-day Premium trial

Advertisement